[HISTORY: Adopted by the Mayor and Council of the Town of Selbyville
at time of adoption of Code (see Ch. 1, General Provisions, Art. I). Amendments
noted where applicable.]
Certain documents, three copies of which are on file in the office of
the Town of Selbyville Town Clerk and the Town of Selbyville, being marked
and designated as International Plumbing Code, including Appendix Chapters,
as published by the International Code Council be and is hereby adopted as
the Code of the Town of Selbyville for regulating the design, construction,
quality of materials, erection, installation, alteration, repair,
location, relocation, replacement, addition to, use or maintenance of plumbing
systems in the Town of Selbyville and providing for the issuance of permits
and collection of fees therefor; and each and all of the regulations, provisions,
conditions and terms of such International Plumbing Code, 1997 Edition, published
by the International Code Council on file in the office of Town of Selbyville
are hereby referred to, adopted and made a part hereof as if fully set out
in this chapter.
The following sections are hereby revised:
Section 101.1. Insert: Town of Selbyville.
|
Section 106.5.2. is deleted.
|
Section 106.5.3. is deleted.
|
Section 108.4. is revised to read as follows:
|
Violations and penalties. Any person who shall violate a provision of
this code or shall fail to comply with any of the requirements thereof or
who shall erect, install, alter or repair plumbing work in violation of the
approved construction documents or directive of the Code Official, or of a
permit or certificate issued under the provisions of this code, shall be punishable
by a fine of $200 per day, plus costs, including attorney's fees. Each day
that a violation continues after due notice has been served shall be deemed
a separate offense.
|
Section 108.5. Insert: "$50 per day" in the first blank and "$200 per
day" in the second blank.
|
Section 305.6.1. is revised to read as follows:
|
Sewer depth. Building sewers that connect to private sewage disposal
systems shall be a minimum of inches (mm), as established by the town, below
finished grade at the point of septic tank connection. Building sewers shall
be a minimum of inches, as established by the town (mm), below grade.
|
Section 904.1. is revised to read as follows:
|
Roof extension. All open vent pipes that extend through a roof shall
be terminated at least a number of inches (mm), as established by the town,
above the roof, except that where a roof is to be used for any purpose other
than weather protection, the vent extensions shall be run at least seven feet
(2134 mm) above the roof.
|