[Amended 8-22-2006 by Ord. No. 1870; 2-27-2018 by Ord. No. 2550]
A.
Height, area and bulk requirements for
the various districts shall be as indicated in the chart below,[1] together with other height, area and bulk requirements
contained in this chapter.
[1]
Editor's Note: The General Table of Height, Area and Bulk Requirements, Table I, is included at the end of this chapter.
B.
The height, area and bulk requirements
for multifamily structures when permitted in the MR, GR, UR, UB, M,
B-1, B-2, B-3, C-1, CR-1, C-2, C-3, C-4 and C-5 Districts (as may
be applicable) shall be as set forth in Tables II and III. The “Lot
Area (square feet per dwelling unit)” calculation set forth
in Tables II and III shall be determined using only the area of land
within the zoning district or conditional use where the multifamily
structures will be located within the development.[2]
[Amended 9-21-2021 by Ord. No. 2802]
[2]
Editor's Note: Tables II and III are included
at the end of this chapter.
C.
The list of permitted uses within the B-2, B-3, C-2, C-3, C-4 and C-5 Districts shall be as set forth in Table IV. In the event of any discrepancy between the information set forth in Table IV and text of Chapter 115, Articles XA, XB, XIB, XIC, XID, XIE and XIF, the text of those articles shall be controlling.[3]
[3]
Editor's Note: Table IV is included at the end of this chapter.
