All users of the District's POTW will comply with all standards
and requirements of the Act and standards and requirements promulgated
pursuant to the Act, including but not limited to 40 CFR Parts 406
to 471.
A.
No user shall contribute or cause to be contributed, in any manner
or fashion, directly or indirectly, any pollutant or wastewater which
will interfere with the operation or performance of the POTW. These
general prohibitions apply to all such users of a POTW whether or
not the user is subject to National Categorical Pretreatment Standards,
or any other national, state, or local pretreatment standards or requirements.
B.
Without limiting the generality of the foregoing, a user may not
contribute the following substances to the POTW:
(1)
Any solids, liquids, or gases which, by reason of their nature or
quantity, are or may be sufficient, either alone or by interaction
with other substances, to cause a fire or an explosion or be injurious,
in any way, to the POTW, or to the operation of the POTW. At no time
shall both of two successive readings on a flame-type explosion hazard
meter, at the point of discharge into the system (or at any other
point in the system) be more than 25% nor any single reading be more
than 40% of the lower explosive limit (LEL) of the meter. Unless explicitly
allowable by a written permit, prohibited materials include, but are
not limited to, gasoline, kerosene, naphtha, benzene, toluene, xylene,
ethers, alcohols, carbides, hydrides, and sulfides, and any other
substance which the District, the state, or the EPA has determined
to be a fire hazard, or hazard to the POTW.
(2)
Solid or viscous substances which may cause obstruction to the flow
in a sewer or otherwise interfere with the operation of the wastewater
treatment facilities. Unless explicitly allowable by a written permit,
such substances include, but are not limited to, grease, garbage with
particles greater than 1/2 inch in any dimension, animal guts or tissues,
paunch manure, bones, hair, hides or fleshings, entrails, whole blood,
feathers, ashes, cinders, sand, spent lime, stone or marble dust,
metal, glass, straw, shavings, grass clippings, rags, spent grains,
spent hops, wastepaper, wood, plastics, gas, tar asphalt residues,
residues from refining or processing fuel or lubricating oil, mud,
or glass or stone grinding or polishing wastes.
(3)
Any wastewater having a pH less than 5.0 or greater than 10.0, unless
the POTW was specifically designed to manage such wastewater, or wastewater
having any other corrosive property capable of causing damage or hazard
to structures, equipment and/or POTW personnel.
(4)
Any wastewater containing toxic pollutants in sufficient quantity,
either singly or by interaction with other pollutants (including heat),
to injure or interfere with any wastewater treatment process, constitute
a hazard to humans or animals, create toxic effect in the receiving
waters of the POTW, or to exceed the limitation set forth in a categorical
pretreatment standard. A toxic pollutant shall include, but not be
limited to, any pollutant identified pursuant to Section 307(A) of
the Act.
(5)
Any noxious or malodorous solids, liquids, or gases which either
singly or by interaction with other wastes are sufficient to create
a public nuisance or a hazard to life or are sufficient to prevent
entry into the sewers for their maintenance or repair.
(6)
Oils and grease: any commercial, institutional, or industrial wastes
containing fats, waxes, grease, or oils which become visible solids
when the wastes are cooled to 10º C. (50º F.); any petroleum
oil, nonbiodegradable cutting oil, or products of mineral oil origin,
in excess of 100 mg/1 or in amounts that will cause interference or
pass-through.
(7)
Any wastewater which will cause interference or pass-through.
(8)
Any wastewater with objectionable color which is not removed in the
treatment process, such as, but not limited to, dye wastes, and vegetable
tanning solutions.
(9)
Any solid, liquid, vapor, or gas having a temperature higher than
65º C. (150º F.); however, such materials shall not cause
the POTW treatment plant influent temperature to be greater than 40
º C. (104º F.). The Superintendent reserves the right, in
certain instances, to prohibit or limit the discharge of wastes whose
maximum temperatures are lower than 65º C.
(10)
Unusual flow rate or concentration of wastes, constituting slugs,
except by industrial wastewater permit.
(11)
Any wastewater containing any radioactive wastes except as approved
by the Superintendent, and in compliance with applicable state and
federal regulations.
(12)
Any wastewater which causes a hazard to human life or which
creates a public nuisance, either by itself or in combination, in
any way, with other wastes.
(13)
Any wastewater with a closed cup flashpoint of less than 140º
F. or 60º C. using the test methods specified in 40 CFR 261.21.
(14)
Any pollutants which result in the presence of toxic gases,
vapors or fumes within the POTW in a quantity that may cause acute
worker health and safety problems.
No person shall discharge, directly or indirectly, into the POTW, wastewater containing any of the following substances in concentrations exceeding those specified below on either a daily or an instantaneous basis, except by permit or as provided for in § 382-64. Concentration limits are applicable to wastewater effluents at the point just prior to discharge into the POTW ("end of pipe" concentrations).
Effluent Concentration Limit – mg/1
| ||
---|---|---|
Substance
(A)
|
Allowable Average Daily
(B)
|
Allowable Maximum Instantaneous
(C)
|
Aluminum
|
Allowable concentration limits have not been established. Limits
will be established by the Superintendent when they are necessary
and appropriate.
| |
Antimony
| ||
Arsenic
| ||
Barium
| ||
Beryllium
| ||
Bismuth
| ||
Bromine
| ||
Cadmium
| ||
Chlorides
| ||
Chlorine
| ||
Chromium (hex)
| ||
Chromium (tot)
| ||
Cobalt
| ||
Copper
| ||
Cyanide (complex)
| ||
Cyanide (free)
| ||
Fluorides
| ||
Gold
| ||
Iodine
| ||
Iron
| ||
Lead
| ||
Manganese
| ||
Mercury
| ||
Molybdenum
| ||
Nickel
| ||
Phenols, total
| ||
Selenium
| ||
Silver
| ||
Sulfates
| ||
Sulfides
| ||
Tin
| ||
Titanium
| ||
Vanadium
| ||
Zinc
|
A.
Except for chromium (hex), all concentrations listed for metallic
substances shall be as "total metal," which shall be defined as the
value measured in a sample acidified to a pH value of two or less,
without prior filtration.
B.
As determined on a composite sample taken from the user's daily discharge
over a typical operational and/or production day.
C.
As determined on a grab sample taken from the user's discharge at
any time during the daily operational and/or production period.
D.
Other substances which may be limited are:
Aliphatic and aromatic alcohols and acids
| |
Aliphatic and aromatic aldehydes and ketones
| |
Aliphatic and aromatic esters
| |
Aliphatic and aromatic halogenated compounds
| |
Aliphatic and aromatic nitro, cyano and amino compounds
| |
Alkanes, alkenes and alkynes
| |
Antibiotics
| |
Benzene derivatives
| |
Chemical compounds which, upon acidification, alkalinization,
oxidation or reduction, in the discharge or after admixture with wastewater
and its components in the POTW, produce toxic, flammable, or explosive
compounds
| |
Pesticides, including algicides, fungicides, herbicides, insecticides,
rodenticides
| |
Phthalates
| |
Polyaromatic and polynuclear hydrocarbons
| |
Total toxic organics, TTP, as defined in 40 CFR 433.11
| |
Toxic organic compounds regulated by federal pretreatment standards
| |
Unsaturated aliphatics, including those with an aldehyde, ketone
ornitrile functional group
| |
Viable pathogenic organisms from industrial processes or hospital
procedures
|
A.
At no time shall the influent to the POTW contain quantities in excess
of those specified below:
Allowable POTW Influent Loading
| ||
---|---|---|
Substance
|
Average Daily (pounds per day)
| |
Aluminum
|
Average daily pound limits have not been established. They will
be established by the Superintendent when they are necessary and appropriate.
| |
Antimony
| ||
Arsenic
| ||
Barium
| ||
Beryllium
| ||
Bismuth
| ||
Bromine
| ||
Cadmium
| ||
Chromium (hex)
| ||
Chromium (total)
| ||
Cobalt
| ||
Copper
| ||
Cyanide (complex)
| ||
Cyanide (free)
| ||
Fluoride
| ||
Gold
| ||
Iron
| ||
Lead
| ||
Manganese
| ||
Mercury
| ||
Nickel
| ||
Phenols (total)
| ||
Selenium
| ||
Silver
| ||
Sulfide
| ||
Tin
| ||
Titanium
| ||
Vanadium
| ||
Zinc
|
B.
The Superintendent shall determine the total allowable influent load
of each substances from significant industrial users. In determining
the total load of each substance that significant industrial users
shall be allowed to discharge, the Superintendent shall consider:
(1)
The quantities of each substance that are uncontrollable because
they occur naturally in wastewater;
(2)
The quantities of each substance that are anthropogenic but are nonetheless
uncontrollable;
(3)
Historical discharge trends;
(4)
Past pollution control efforts of each significant industrial user
as compared to other significant industrial dischargers of the same
substance;
(5)
Potential for growth in the POTW service area;
(6)
Potential for more restrictive regulatory requirements to be placed
on the POTW discharge or sludge disposal or sludge reuse method; and
(7)
Treatability of the substance. The Superintendent shall apply a minimum
15% safety factor to be protective of the POTW.
C.
To assure that the total loads so calculated, for each substance,
are not violated, the Superintendent shall issue permits to significant
industrial users limiting discharge loads.
A.
Limitations on wastewater strength or mass discharge contained in
this chapter may be supplemented with more stringent limitations when,
in the opinion of the Superintendent:
(1)
The limitations in this chapter are not sufficient to protect the
POTW;
(2)
The limitations in this chapter are not sufficient to enable the
POTW treatment plan to comply with applicable water quality standards
or the effluent limitations specified in the POTW's SPDES permit;
(3)
The POTW sludge will be rendered unacceptable for disposal or reuse
as the District desires, as a result of discharge of wastewaters at
the above prescribed concentration limitations;
(4)
Municipal employees or the public will be endangered; or
(5)
Air pollution and/or groundwater pollution will be caused.
B.
The limitations on wastewater strength or mass discharge shall be
recalculated not less frequently than once every five years. The results
of these calculations shall be reported to the Town Board. This chapter
shall then be amended appropriately. Any issued industrial wastewater
discharge permits, which have limitations, based directly on any limitations,
which were changed, shall be revised and amended, as appropriate.
The Superintendent shall have the authority to copy any record
related to wastewater discharges to the POTW.
A.
Except where expressly authorized to do so by an applicable pretreatment
standard, no user shall ever increase the use of process water or,
in any other way, attempt to dilute a discharge as a partial or complete
substitute for adequate treatment to achieve compliance with a pretreatment
standard.
B.
Dilution flow shall be considered to be inflow.
Grease, oil, and sand interceptors shall be provided, when,
in the opinion of the Superintendent, they are necessary for the proper
handling of wastewater containing excessive amounts of grease, flammable
substances, sand, or other harmful substances; except that such interceptors
shall not be required for private living quarters or living units.
All interceptors shall be of type and capacity approved by the Superintendent
and shall be so located to be easily accessible for cleaning and inspection.
Such interceptors shall be inspected, cleaned, and repaired regularly,
as needed, by the owner, at his expense.
Solid waste grinders at or serving commercial establishments,
institutions or industries shall not discharge into the District POTW
if there is a combined sewer overflow (CSO) on the sewer lines conveying
the waste to the POTW treatment plant.
The District may reject a user's wastewater, on recommendation of the Superintendent, when it is has been determined that the wastewater contains substances or possesses characteristics which have a deleterious effect on the POTW and its processes, or on the receiving water, or which constitute a public nuisance or hazard. See § 382-86.