[Amended 3-17-2022 by Ord. No. 2022-02]
The following Table of Uses identifies those principal and accessory uses in the Township that are permitted by right, permitted as a conditional use or permitted as a special exception, and that are prohibited.[1]
[1]
Editor's Note: The Table of Uses is included as an attachment to this chapter.
A. 
The following Table of Dimensional Requirements states the dimensional requirements of each district, except as otherwise provided in this chapter.
Table of Dimensional Requirements
District
Min. Lot Area
Min. Lot Width
(feet)
Min. Front Setback**†
(feet)
Min. Rear Setback†**
(feet)
Min. Side Setback**†
(feet)
Min. Open Space
Maximum Lot Coverage
Max. Height‡
(feet)
Agricultural Conservation
3 acres (130,680 sf)
250
30
25
10
-
35%
35
Open Countryside
2 acres (87,120 sf)
200
40
25
10
20%
35%
35
Baltimore Pike Corridor
1 acre (43,560 sf)*
150
40
30
15
20%
50%
40
Baltimore Pike Corridor Intensive Uses Overlay
3 acres (130,680 sf)
250
40
35
20
65%
50
NOTES:
*
For a multiple-family dwelling use, a minimum of 1,500 square feet of floor area is required per dwelling unit and a single multiple-family structure shall contain no more than six dwelling units.
**
Where a lot adjacent to an historic building is proposed for nonresidential use or structure, see also § 110-402T(2).
Where a lot within an historic district is proposed for a nonresidential use or structure, the front, side and rear setback shall be increased by 50%.
No maximum height requirement shall apply to a structure in normal agricultural operation use. The maximum height requirement for an amateur radio antenna shall be 65 feet.
B. 
Flag lot.
[Added 9-3-2020 by Ord. No. 2020-05[1]]
(1) 
A flag lot is permitted where all of the following requirements are satisfied:
(a) 
The flag lot and the remainder lot (remaining after subdivision of the flag lot) each is a minimum of 10 acres;
(b) 
The flag lot pole is a minimum of 50 feet in width; and
(c) 
The number of flag lots created by subdivision does not exceed two per lot of record (parent tract) as of the effective date of this subsection.
(2) 
Note: The Township's Subdivision and Land Development Ordinance[2] states additional requirements for purposes of regulation of a subdivision to create a flag lot.
[2]
Editor's Note: See Ch. 86, Subdivision and Land Development.
[1]
Editor's Note: This ordinance also provided for the redesignation of former Subsections B and C as Subsections C and D, respectively.
C. 
Accessory structure and accessory use.
(1) 
In the BPC District, an accessory structure or accessory use not contained, conducted or operated within a structure shall not be located, conducted or operated within the minimum front setback.
(2) 
Except where otherwise provided in this chapter, an accessory structure or an accessory use not contained, conducted or operated within a structure:
(a) 
Shall not be located, conducted or operated within the minimum front setback stated for the district in which located as provided in the Table of Dimensional Requirements.
(b) 
Shall not be located closer than 10 feet from a lot line or one-half of the minimum rear setback stated for the district in which located as provided in the Table of Dimensional Requirements, whichever is larger.
(c) 
Shall not be located closer than 10 feet from a lot line or one-half of the minimum side setback stated for the district in which located as provided in the Table of Dimensional Requirements, whichever is larger.
(d) 
Shall not exceed the height requirement for the district in which located as provided in the Table of Dimensional Requirements.
D. 
Within any residential development existing at the time of the adoption of this subsection and which is subject to the Pennsylvania Uniform Planned Community Act, 68 P.S. 5101 et seq., the applicable setback requirement shall be no larger than the setback applied to buildings or structures of similar character (e.g. principal dwelling, accessory garage) constructed on lots in the planned community prior to the adoption of this subsection.
[Added 6-21-2018 by Ord. No. 2018-01]