[R.O. 2009 § 495.010; Ord. No. 3001 § 1, 12-23-2008]
The provisions of this Article shall
apply to the construction or reconstruction of all Driveways and/or
curb cuts in the City.
[R.O. 2009 § 495.020]
As used in this Article, the following
terms shall have the meanings and usages indicated:
Any Lot that is not deemed to be a Residential Lot, Multi-Family
Complex, or Industrial Use as defined herein.
Any Lot with a Principal Light or Heavy Industrial Use and
located in the "IP-1" or "PID" District.
Any Lot containing one (1) or more Buildings used for Multi-Family
Dwellings or designated as a common area for a Multi-Family Complex.
Any Lot containing a Single-Family or Two-Family Dwelling
or designated as a common area for a subdivision for Residential Use.
Where not inconsistent with the language or intent herein, the additional definitions set forth in Section 400.030 are incorporated herein and shall apply.
[R.O. 2009 § 495.030; Ord. No. 3001 § 1, 12-23-2008]
A.
Interior Lots.
1.
On all Lots up to two hundred (200)
feet wide at the Street, one (1) Driveway not more than thirty (30)
feet or thirty-five percent (35%) of the Lot Width, whichever is less,
from the Street to the required Front Setback shall be permitted.
For radii, the width may be increased by not more than ten (10) feet
at the edge of the pavement.
2.
On all Lots in excess of two hundred
(200) feet wide at the Street, the following shall apply:
a.
One (1) Driveway not to exceed twenty-four
(24) feet in width from the Street to the required Front Setback.
For radii, the width may be increased by not more than ten (10) feet
at the edge of pavement.
b.
Two (2) Driveways with an aggregate
width from the Street to the required Front Setback, not to exceed
forty-four (44) feet, shall be allowed, provided that a minimum of
one hundred (100) feet is required between Driveways at the Street.
A maximum of ten (10) feet may be added for radii of each Driveway
at the edge of the pavement.
c.
A wider Driveway may be permitted
behind the Front Setback to serve Private Garages and turnarounds.
d.
A circular Driveway may be permitted
if the pavement width is less than eighteen (18) feet.
B.
Corner Lots.
1.
Corner Lots may be considered as
two (2) Interior Lots if the width at the Street is greater than two
hundred (200) feet on each Street in order to allow one (1) Driveway
on each Frontage; provided, however, that not more than two (2) Driveways
shall be allowed per Lot.
2.
On any Corner Lot, no Driveway shall
be permitted to be closer than thirty (30) feet to the point of Intersection.
[R.O. 2009 § 495.040; Ord. No. 3001 § 1, 12-23-2008; Ord. No. 4270, 10-27-2022]
A.
Single Entrance And Exit Driveways.
1.
The minimum width of entrance and
exit Driveways shall be fourteen (14) feet at the right-of-way.
2.
The maximum width of entrance Driveways
shall be eighteen (18) feet at the right-of-way.
3.
The maximum width of exit Driveways
shall be twenty-four (24) feet at the right-of-way.
4.
There shall be a minimum distance
of eighty (80) feet between Driveways measured at the right-of-way.
5.
The minimum distance from the point
of Intersection shall be eighty (80) feet on Comer Lots.
6.
All Driveways shall be constructed
with a minimum radius of twenty (20) feet. The maximum radius shall
be forty (40) feet unless it is determined by the Director of Public
Works that a larger radius is required to provide adequate turning
movements.
B.
Combined Entrance/Exit Driveways.
1.
The minimum width of combination
entrance/exit Driveways shall be twenty-four (24) feet at the right-of-way.
2.
The maximum width of combination
entrance/exit Driveways shall be thirty-six (36) feet at the right-of-way,
except that the maximum width may be increased to forty-two (42) feet
to allow one (1) island not to exceed six (6) feet in width between
the entrance and exit.
3.
The minimum distance from the point
of Intersection shall be one hundred twenty (120) feet.
4.
The minimum radius for all Driveways
shall be twenty (20) feet. The maximum radius shall be forty (40)
feet unless determined by the Department of Public Works that a larger
radius is required to provide adequate turning movements.
5.
The minimum distance between Driveways
on the same Lot shall be one hundred twenty (120) feet at the Street.
[R.O. 2009 § 495.050; Ord. No. 4270, 10-27-2022]
A.
The minimum width of Driveways shall be
twenty-four (24) feet measured at the right-of-way.
B.
The maximum width of Driveways shall be
thirty-six (36) feet measured at the right-of-way.
C.
The minimum distance from the point of
Intersection shall be one hundred fifty (150) feet.
D.
The minimum distance between two (2) Driveways
on the same Lot shall be two hundred (200) feet measured at the right-of-way.
E.
The minimum radii for all Driveways shall
be twenty (20) feet.
|
The width, number of Driveways, or radii may be increased or
decreased as determined by the Director of Public Works to provide
for high traffic volumes or movement of large trucks.
|
[R.O. 2009 § 495.060; Ord. No. 3001 § 1, 12-23-2008]
A.
All Driveways must be paved with concrete
or Asphalt.
B.
Any portion of all Driveways located within
a Street shall be paved with concrete in accordance with the following:
1.
Driveways connecting a Residential
Lot to the edge of pavement of the adjacent Street shall be a minimum
of six (6) inches of concrete on four (4) inches of compacted aggregate
base.
2.
Driveways connecting a Commercial/Business,
Multi-Family Complex, or Industrial Lot to the edge of pavement of
the adjacent Street shall be a minimum of eight (8) inches of concrete
on four (4) inches of compacted aggregate base.
C.
Driveways constructed of concrete and located
on a Residential Lot shall be a minimum of four (4) inches on four
(4) inches of compacted aggregate base.
D.
Driveways constructed of Asphalt and located
on a Residential Lot shall be a minimum of four (4) inches of Type
"C" Asphalt on six (6) inches of compacted aggregate base.
E.
Driveways constructed of concrete and located
on a Commercial/Business, Multi-Family Complex, or Industrial Lot
shall be a minimum of six (6) inches in depth on four (4) inches of
compacted aggregate base.
F.
Driveways constructed of Asphalt and located
on a Commercial/Business, Multi-Family Complex, or Industrial Lot
shall be a minimum of four (4) inches in depth on six (6) inches of
compacted aggregate base.
