The following documents shall be submitted for plat approval:
A. The plat to be filed with the County Clerk shall be printed upon
linen or plastic or be clearly drawn in India ink upon tracing cloth.
The size of the sheet shall be 20 inches by 20 inches or 24 inches
by 36 inches, including a margin for binding of two inches outside
of the border along the left side and a margin of one inch outside
the border along the remaining sides. The plat shall be drawn at the
same scale required for the preliminary plat and oriented with the
North point at the top of the map. When more than one sheet is required,
an additional index sheet of the same size shall be filed showing
to scale the entire subdivision with lot and block numbers clearly
legible. The plat will show:
(1) The proposed subdivision name or identifying title and the name of
the Town and county in which the subdivision is located; the name
and address of record owner and subdivider; name, license number and
seal of the licensed land surveyor.
(2) The street lines, pedestrianways, lots, reservations, easements and
areas to be dedicated to public use.
(3) Sufficient data acceptable to the Town Engineer to determine readily
the location, bearing and length of every street line, lot line, boundary
line and to reproduce such lines upon the ground. Where applicable,
these should be referenced to monuments included in the state system
of plane coordinates and, in any event, should be tied to reference
points previously established by a public authority.
(4) The length and bearing of all straight lines, radii, length of curves
and central angles of all curves and tangent bearings shall be given
for each street. All dimensions and angles of the lines of each lot
shall also be given. All dimensions shall be shown in feet and decimals
of a foot. The plat shall show the boundaries of the property, location,
graphic scale and true North point.
(5) The plat shall also show by proper designation thereon all public
open spaces for which deeds are included and those spaces title to
which is reserved by the developer. For any of the latter, there shall
be submitted with the subdivision plat copies of agreements or other
documents showing the manner in which such areas are to be maintained
and the provisions made therefor.
(6) All offers of cession and covenants governing the maintenance of
unceded open space shall bear the certificate of approval of the Town
Attorney as to their legal sufficiency.
(7) Lots and blocks within a subdivision shall be numbered and lettered
in alphabetical order in accordance with the prevailing Town practice.
(8) Permanent reference monuments shall be shown and shall be constructed
in accordance with specification of the Town Engineer. When referenced
to the state system of plane coordinates, they shall also conform
to the requirements of the State Department of Public Works. They
shall be placed as required by the Town Engineer and their location
noted and referenced upon the plat.
(9) All lot corner markers shall be permanently located satisfactorily
to the Town Engineer at least 3/4 inch (if metal) in diameter and
at least 24 inches in length and located in the ground to existing
grade.
(10)
Monuments of a type approved by the Town Engineer shall be set
at all corners and angle points of the boundaries of the original
tract to be subdivided and at all street intersections, angle points
in street lines, points of curve and such intermediate points as shall
be required by the Town Engineer.
B. Construction drawings, including plans, profiles and typical cross
sections, as required, showing the proposed location, size and type
of streets, sidewalks, streetlighting standards, street trees, curbs,
water mains, sanitary sewers and storm drains, pavements and subbase,
manholes, catch basins and other facilities.