[Ord. No. 08-06 §8, 12-30-2008]
A. 
A certain document, three (3) copies of which one (1) copy is on file in the office of the Cass County Clerk and the remaining two (2) copies may be maintained in the Building Codes office of the County of Cass, Missouri, being marked and designated as the International Fuel Gas Code, 2006 Edition, including Appendix Chapters A, B and D, as published by the International Code Council, Inc., be and is herby adopted as the Building Code of the County of Cass in the State of Missouri for the control of building and structures as herein provided; and each and all of the regulations, provisions, penalties, conditions and terms of said Building Code are hereby referred to, adopted and made a part hereof, as if fully set out in this Article, with the additions, insertions, deletions and changes, if any, prescribed in Subsection (B) hereof and Section 500.020 of this Chapter.
B. 
The following Sections are hereby revised:
IFGC Section 101.1. Insert: Cass County.
IFGC Section 103. Department of Inspection. Shall be amended as follows: Delete Department of Inspection and insert: Building Codes Department.
IFGC Section 103.1. General. Shall be amended as follows: Delete the entire paragraph and insert: The Codes Administration Department is hereby created and the official in charge thereof for purposes of administration of this code shall be known as the Building Official, Code Official or Director of Codes Department.
IFGC Section 406.4.1. Test pressure. Amend as follows: The test pressure to be used shall be not less than one and one-half times the proposed maximum working pressure, but not less than 10 psig (68.9 kPa) irrespective of design pressure. For welded piping and for piping carrying gas at pressures in excess of fourteen (14) inches (356 mm) water column pressure, the test pressure shall not be less than 60 psig. Where the test pressure exceeds 125 psig (862 kPa), the test pressure shall not exceed a value that produces a hoop stress in the piping greater than 50 percent of the specified minimum yield strength of the pipe.