A. 
PLANNING BOARD approval block.
(1) 
Eight printed copies of the original PLAN shall be submitted for approval and subsequent recording. The size of sheet, margins and scales shall be as required in Article IV, Preliminary Plan. A minimum two-inch-by-six-inch approval block containing the statement "Approved by the Hudson, NH PLANNING BOARD," one line with the words "Date of Meeting: __________," and two lines for the signatures of the PLANNING BOARD Chairman and Secretary. The signature line shall provide space for the signature, follow with the words "Signature Date: __________."
(2) 
The following sentences shall be included within the approval block: "SUBDIVISIONs are valid for two years from the date of PLANNING BOARD meeting final approval. For an APPLICANT to gain an exemption from all subsequent changes in SUBDIVISION regulations, SITE PLAN regulations and changes to the Zoning Ordinance, see NH RSA 674:39."
(3) 
The PLANNING BOARD approval block shall be located on the lower left corner of each sheet in the PLAN set.
B. 
The final PLAT shall show, in addition to all items required under Article IV, Preliminary Plan, the following:
(1) 
Proposed SUBDIVISION name or identifying title, the name and address of OWNER of record and subdivider, and the name, license number and seal of the engineer and/or name and address of surveyor.
(2) 
STREET lines, setback lines, pedestrian ways, LOT lines, LOT sizes in square feet, identification number for each LOT, reservations, easements and areas to be dedicated to public use and areas the title to which is reserved by the developer.
(3) 
STREET cross sections, approximate grades and profiles and designs of any bridges or culverts.
(4) 
Proposed layout of storm drainage, water supply and sewage disposal systems.
(5) 
Typical design and location of each proposed on-LOT sewerage and water system and location and size of each proposed storm pipe and catch basin.
(6) 
Sufficient data to determine readily the location, bearing and length of every STREET line, LOT line, boundary line and to reproduce such lines upon the ground. All dimensions shall be shown to the nearest hundredth of a foot and bearings to the nearest 30 seconds. The error of closure shall be one in 10,000 or better. The final PLAT shall show the boundaries of the property.
(7) 
Location and description of each permanent monument and benchmark, including primary control points and reference to a USGS (United States Geological Survey) benchmark.
(8) 
Reference to recorded SUBDIVISION plats of adjoining platted areas by county registry record, name, date and number.
(9) 
Sworn statement by OWNER dedicating streets, rights-of-way and any sites for public use.
(10) 
A locus plan, drawn at a scale of one inch equals 1,000 feet, which shall depict STREET RIGHT-OF-WAY lines, major utility lines, external property lines, waterways and any feature usually shown on the Official Town Map.
C. 
All sheets of the PLAN set, recommended by STAFF to be recorded, and approved by the PLANNING BOARD, shall be recorded at the Hillsborough County Registry of Deeds at the APPLICANT's expense, with the provision that any subsequent changes to these PLANS might also be required to be so recorded, at the option of the PLANNING BOARD, at the APPLICANT's expense.