The following improvements shall be installed and constructed
by the SUBDIVIDER to the satisfaction of the PLANNING BOARD and under its supervision, either before submission of the final plat, or the SUBDIVIDER together with the final PLAT shall file a bond or make other suitable arrangements as contained in §
289-10.
A. Monuments shall be set at all block corners, angle points, points
of curves in streets, property corners and at any other points the
PLANNING BOARD may deem necessary to control the line of streets.
B. The paved roadway shall have a minimum width in accordance with the type of street, as defined in §
289-3, as follows:
(1) Major streets, collector streets and commercial streets shall be
paved a minimum of 36 feet or wider where the PLANNING BOARD determines
that the nature and/or intensity of the proposed use would require
a wider pavement.
(2) Residential streets, service streets and access streets of 1,000
feet in length or less shall be paved 24 feet wide. Residential streets,
service streets and access streets greater than 1,000 feet in length
shall be paved 28 feet wide.
[Amended 4-24-2019 by
Amdt. No. 2]
C. The roadway shall be constructed in accordance with the specifications
of the Engineering Department and the typical roadway cross-section
as approved by the PLANNING BOARD.
D. All proposed drainage facilities and culverts shall be installed
in accordance with the specifications of the Engineering Department
and as approved by the PLANNING BOARD.
E. The roadway shall be graded and paved to the final grade in accordance
with the profile and cross section submitted.
F. Slope granite curbing shall be installed on both sides of the proposed
roadway.
G. A BITUMINOUS CONCRETE sidewalk four feet wide shall be constructed
on one side of the proposed roadway.