[Ord. No. 8.465 (2645) §2, 8-18-2016; Ord. No. 14.541 (Bill No. 2761), 12-19-2019; Ord. No. 14.559 (Bill No. 2832), 7-21-2022]
This provision shall apply to an existing private street or privately maintained street.
[Ord. No. 8.465 (2645) §2, 8-18-2016; Ord. No. 14.541 (Bill No. 2761), 12-19-2019; Ord. No. 14.559 (Bill No. 2832), 7-21-2022]
A. 
Before an existing private street or privately maintained street can be accepted for public maintenance it shall meet the following minimum requirements:
1. 
In areas identified by the Public Works Director, existing street pavement will be excavated and replaced with a new rock and asphalt base mix pavement or concrete pavement as appropriate.
2. 
If the Public Works Director determines that the street surface is not in an acceptable condition, a new ultra-thin asphalt-wearing surface or Type C asphalt overlay will be required.
3. 
Appropriate street signage will be installed.
4. 
One side of the street will be designated "No Parking" if required by existing standards.
5. 
A minimum pavement width of twenty (20) feet will be in place or constructed with adequate easements or new right-of-way granted to allow for City maintenance.
6. 
Streets with no ending cul-de-sac will provide for a street-ending T-section.
7. 
Although the installation of new stormwater systems will not be required unless the Public Works Director determines that the proposed street improvements will increase existing stormwater drainage concerns, in which case appropriate stormwater control measures will be installed, any existing stormwater system will be repaired or replaced to a condition that allows it to operate normally, as determined by the Public Works Director.
8. 
Although the installation of new sidewalks will not be required unless it is necessary to complete an existing partially finished sidewalk system, any existing sidewalks will be repaired to a condition that allows public use without hazard and/or ensures compliance with all federal and State requirements as determined by the Public Works Director in conformance with the standard specifications.